Machine tool lubrication and daily maintenance - Solutions - Huaqiang

Single chip microcomputer STM32L151CCU6

Probe domestic high current needle 150 head diameter 3.0 thread needle high current needle total

SMD aluminum electrolytic capacitor

1. Before using the machine tool, you must be familiar with the installation, commissioning, use and maintenance of the machine tool. Before starting the machine, check whether the components are in good condition, whether the movement is flexible, whether the workpiece is clamped, and whether the operation is safe. After confirming, open the empty car for five minutes, and the high-speed cutting (3000 rpm or more) requires only 15 minutes of empty space for cutting.

2. The machine tool spindle uses high-speed grease. After using for a period of time, the spindle should be disassembled and cleaned with kerosene and then smeared with high-speed grease.

3, the machine tool uses 32 # mechanical oil, rails, carriages, handle bearings, sliding sleeves and other sports parts, at least 2 times per shift (8 hours / shift).

4, the machine should be kept clean, timely chip removal, water and dirt are not allowed in the active parts.

5. The middle of the large and small pallets is equipped with an adjusting plug iron. After using for a period of time, the gap between the pallets can be adjusted by adjusting the plug screws.

6. The middle of the large carriage and the guide rail is equipped with an adjusting plug iron. The gap between the carriage and the bed rail can be adjusted by adjusting the screws on the pressure plate.